Connex Waterproof Switch Panel – 6 Switch

Frequently Asked Questions

1. What is the Connex Waterproof Switch Panel 6 Switch used for?
   It gives you six illuminated switches so you can control multiple 12V accessories from one central panel.
2. Is it waterproof?
   Yes. The front panel is sealed and splash-resistant, which makes it suitable for outdoor, marine and off-grid setups.
3. What accessories can I run from it?
   LED lights, camp lighting, water pumps, fridges, radios, fans and most low to medium draw 12V gear.
4. How do I wire it?
   Connect each switch to its accessory and the panel to a fused 12V supply.
5. Can it be used in a boat?
   Yes. It is designed with corrosion-resistant materials suited to marine environments.
6. Does it come pre-labelled?
   Yes. Switch labels are included so you can mark each circuit clearly.
7. Is it easy to install?
   Yes. Mount the panel, connect the power feed through a fuse and wire each accessory to its switch.
8. Will the switches light up?
   Yes. The switches are backlit so you can see them in the dark.
9. Does it drain the battery?
   Switch backlighting uses very low power and should not affect a healthy battery.
10. Can I hardwire it permanently?
    Yes. It is made for long term installation in 4WDs, caravans and camper trailers.

Tips & Tricks

• Installation Instructions
  1. Choose a Mounting Position
     Select a flat, accessible surface where the panel can be reached easily.
     Avoid direct water flow or high heat.
  2. Prepare the Panel Cutout (if recess mounting)
     Measure and mark the panel outline, then cut the opening if needed.
  3. Connect the Main Power Feed
     • Run a positive 12V supply wire from the battery to the switch panel input.
     • Install an inline fuse close to the battery.
     • Connect the negative wire to the vehicle’s chassis or main earth point.
  4. Wire Each Accessory
     • Connect the output wire from each switch to the positive wire of the accessory.
     • Ensure each accessory has a proper earth return.
  5. Secure the Panel
     Use the supplied screws to firmly mount the panel.
  6. Test Each Circuit
     Turn each switch on and confirm the accessory responds correctly.
  7. Final Check
     Ensure all wiring is neat, secured and away from sharp edges or moving parts.

  ---

  Tips and Tricks (Including Installation Tips)

  • Plan which accessories belong on each switch so the layout feels natural.
  • Use heat shrink connectors for a clean and long lasting finish.
  • Keep the main fuse as close to the battery as possible for safety.
  • Use labels to make night time operation quicker and easier.
  • Run thicker gauge wire if powering higher draw accessories.
  • Group wiring into tidy looms to make future troubleshooting simple.
  • In marine setups, use marine grade tinned copper cable to prevent corrosion.
  • Avoid daisy chaining earths for high draw accessories. Give each one a proper ground.
  • Before final mounting, test the panel loose to ensure all circuits function.
  • If mounting in a dusty or wet location, add a small rubber or foam gasket behind the panel.
  • Recheck screws and terminals every few months, especially if used in a 4WD or boat

Product Specifications